Ultra Lightweight headset NC-400Uv2 MTM (made-to-measure) is a new generation product, being not only a response to current trends in air transport, but also designing the development trends of this industry.
NAVCOMM is currently the only manufacturer offering such a solution in the aviation industry.
Differences from the previous version:
Due to the need to make a cast of the ear canal, this product is currently available only in Poland
60 Item Items
Warning: Last items in stock!
|Passive noise suppression||34dB|
|Speakers frequency response||50Hz-20kHz|
|Speakers impedance||150Ohm mono, 300Ohm stereo|
|Audio output||2x AUX 3,5mm|
|Weight||40g (without cable). 130g (with cable)|
|Connector type||PJ-055, PJ068|
|Mono / stereo switch||Yes|
|GA microphone preamp||Yes|
NC-400U is a unique design that uses two innovative technologies - balanced armature instead of traditional membrane speakers and made-to-measure earbuds instead of universal silicone inserts or with so-called memory foam.
The combination of both these solutions allowed us to create a product with exceptional parameters in terms of damping and comfort of use. A product that will work just as well in private and commercial aviation. And finally, a product that is a viable alternative to expensive solutions based on active noise canceling systems.
In traditional aviation headsets, damping cups are responsible for attenuating noise. This solution is effective but not without flaws. To dampen the acoustic wave, the screen must have the right thickness, and this results in an increase in weight. In the case of lightweight headphones, only a small part of the entrance to the ear canal is shielded.
Thanks to this, we can increase the screening layer without significant weight lifting and more effectively isolate the ear membrane from outside noise. Unfortunately, the large diversity in the construction of the auditory canal in individuals does not allow to make universal earbuds with the appropriate level of damping, and even if they will be available in several sizes. Also using the so-called memory foam we are not able to significantly improve the soundproofing of this element. This problem can be solved only by made-to-measur earbuds "to size" based on the previously collected cast.
That is why we chose this solution when designing the NC-400Uv2 model, as it is the only one that guarantees an appropriate level of attenuation in lightweight mobile headphones. However, made-to-measure earbuds are hard to connect with a traditional membrane speaker - it is simply too big for such a system. In this case, the solution turned out to be a new type of transducers called Balanced Armature (BA). Their high efficiency, and small dimensions perfectly harmonize with the system based on acoustic signal transmission via a acoustic tube, at the end of which is a made-to-measure earplug.
NC-400Uv2 headphones in the field of electrical parameters are not different from the standard headsets. The balanced armature drivers have an impedance matching the standard on-board installations (300 OHm mono and 150 Ohm stereo), and the mounted microphone in combination with our latest preamplifier will ensure full compatibility with the majority of third party headsets.
The NC-400Uv2 model also has a built-in volume control, mono-stereo switch, and two 3.5mm jack sockets for external audio sources, e.g. telephone, mp3, GPS, or an external Bluetooth module in the set that allows pairing of headphones with other devices using this communication standard.
The NC-400Uv2 headphones are equipped with a standard pair of PJ connectors.
1 149,00 zł
1 999,00 zł
1 999,00 zł
1 199,00 zł 1 699,00 zł
1 699,00 zł 1 799,00 zł
1 899,00 zł 1 999,00 zł